Floor Finish Coating (ESD)

Products > Flooring
Dissipative floor coating
It gives dissipative characteristics to a standard floor, and it is excellent in maintaining the conductive floor in operating rooms, clean rooms and data processing centres. It may also be used to mantain the table mat’s dissipative surfaces.
Rs < 10^11 Ω
First treatment
– well wash the floor with the stripper.
– rinse with clean water.
– when dry apply two thin coats on the floor (yeld: 1lt for approx. 25)
Ordinary maintenance
– sweep the floor with a wet broom, then wash it with the cleaner diluted in water at 1-5% ratio
Maintenance with spray
– Dilute the coat in water at 30% ratio, spray it on the floor and then polish by a one brush machine, provided with a suitable scotch-bride (yeld: 1lt for approx 100m²)

7805.876: Liquid coat, 5Kg unit



Low foaming-agent detergent with highly concentrated active substances and alkalinity.
It is used for cleaning and maintenance of the waxed surface.
Biodegradable: up to over 90%

Dilution in water: 1 – 5%
It may be used to wash by hand and with a one-brush polisher or a washing-drying machine.

7805.873: Detergent, 5Kg unit



Dewaxing alkaline detergent have to be used the first time, before applying the coating on the floor. It removes quickly multiple coats of wax and embedded dirt. It is suitable on PVC, rubber and hard floors.
Biodegradable: 90%

Dilution in water: 5 – 10% machine stripping, 12 – 16% manual stripping
Lay off the solution and left it act for 5 minutes, then wash with water.

7805.870: Floor stripper, 5Kg unit



ELECSTAT-112 Dissipative Floor Detergent
ELECSTAT-112 is a non-toxic, low foaming, static dissipative agent for cleaning, used to enhance the features of the existing ESD floors or make a non-ESD floor static dissipative.
Rs: <10^11Ω
Biodegradability: 90%
Dilution in water: 10 to 20%
Application: for manual or mechanical cleaning.

7805.890: Dissipative agent ELECSTAT-112 5kg plastic can



Dissipative floor paint
Two type of paints (Electroguard 30 and Electroguard 40) both in medium gray near to RAL 7035, with an attractive satin gloss finish.
They can be simply applied to existing concrete floors without the need for specialist flooring contractors. They are normally applied with two coats by brush or roller.

7805.854: ELECTROGUARD 40, SINGLE PACK water based static dissipative acrylic paint, 5 litre unit – Number of coats: 2Yeld: aprox. 10/litro – Surface resistivity: 10^9 Ω – Resistance to ground: 10^9 Ω
7805.856: FLOORPOX EPOXY PRIMER for bare concrete floor 12 litre unit (6 litres base + 6 litres activator) – Number of coats: 2Yeld: aprox. 16/litro